Facebook LinkedIn

Wednesday April 1 2020

SILO SERIES #1: AN INTRODUCTION

Minsterport have been working closely with Bindicator over the last few months to provide an in-depth guide on how to make best use of the Bindicator range of silo measuring products. As part of a series, will be posting monthly blog posts entitled “Silo Series”, which aim to give a simple breakdown of the level measurement technology, the types of sensors available and how best to make use of them.

Whilst we are advocates for the weighing method of measuring silo contents (lean more about our bolt-on weighing sensors here), its clear that point level measurement and continuous level measurement within liquid based products can give effective long term results.

In our first of three series we will be looking at the types of level sensors and how to mount them within your tank.

Depending on the application, the type of level sensors used and the location in which they are mounted on your silo will vary.

Level Sensor Technology

Point level sensors, represented on the right side of the silo in the image below, are used when you need to know if the material in a vessel has reached a specific point (for example, high level, low level, or refill point). Some examples of point level devices are VRF II, Pulse Point II and Roto-Bin-Dicator.

Continuous level sensors, represented on the left side of the silo in the image below, monitor the level of material continuously during the filling/emptying process. Options include devices that make contact with the material such as the GP-4 Yo-Yo™ and those that do not such as the F78MP Series air radar sensor or an ultrasonic device.

Mounting Locations

High level mounting locations generally serve two purposes – to fill the vessel to a set capacity and to prevent overfilling of the vessel. When considering continuous level devices please keep the following in consideration:

  • If the vessel is center filled, has center discharge or is a round silo, the level indicator should be located 1/6th of the diameter from the side wall.
  • If the fill is off center, the mounting location should once again be 1/6th of the diameter from the side wall, but it should also be installed at a 90° angle to the fill stream.

The intermediate mounting location is also known as the reorder point. This location is practical when the material must be kept a certain level.

Low level mounting locations typically trigger the need for filling and prevent process or production shutdown.

If you have any questions concerning level sensor mounting locations please call 01943 877358 to speak with customer support or email info@minsterport.com.